SES Software 2006-2007 Patch

 Version 13.2.44

Safe Engineering Services & technologies limited

February 2008

This is a patch update for SES Software 2006-2007, Version 13.2.32; the problems listed below have been fixed in this update.

Prerequisites

You must have installed the full distribution of SES Software 2006-2007 (Version 13.2.32 or Version 13.2.40). If you have installed Version 13.2.32, then you must also install the following patch versions before applying this patch:

  - Version 13.2.40 

You can check the version of the installed SES Software 2006 application by clicking on its "Click here for support information" link in the "Add or Remove Programs" utility in the Control Panel. Any recent patch that is installed will also appear under the "SES Software 2006" entry in the programs list of the utility.

Installation Instructions

1. Once you have downloaded the update file, Patch13244.exe, to a local folder (e.g., C:\Temp), please close all SES software programs prior to installing this update.

2. Run the update file, Patch13244.exe.

3. Click on the Next button to extract the contents of this self-extracting executable to a temporary folder (do not extract to the SES software installation folder).  You may define a temporary folder (e.g., C:\Temp\Patch13244) that is easy to access since you may have to browse to that folder after the extraction process has completed.

4. Click on the Next button to proceed with the extraction process.

5. The update will automatically start after the extraction has been completed. 

(If the update does not start automatically, then execute the Update.exe file manually, from the folder specified in Step 3, to start the update process). 

6. Once the update has completed, you may delete the temporary folder specified in Step 3.

Bug-Fix

The following problems have been fixed in this patch update:

Input Toolbox: When using Imperial (British) units in the TRALIN module (Group Mode), the units of the outer radius of cables is incorrectly identified as “feet”; in reality, this radius is in inches.

Output Toolbox: The default size of the plots produced by Output Toolbox is smaller than in previous versions.

Right-of-Way:

·      In the Total Interference module, a program crash can occur when creating a Total Interference Model File.

·      When creating plots (in the Plot & Report module), other interactive programs (e.g., Microsoft Word) can become very slow and difficult to use.

SESEnviro (Chinese Version): Some of the Radio Interference computation methods are hidden and cannot be selected.